Connecting the Camera to the Remote Control TR-1

You can use the Bluetooth® function to connect the camera to the Remote Control TR-1 (sold separately). Set the camera in advance so that the plug-in “REMOTE CONTROL” can be run.

Necessary preparations

Changing the Plug-in

1. Press and hold the mode button.

The camera status lamp flashes white.

2. Press and hold the shutter button on the Remote Control TR-1 to set it to the pairing state or connection standby state.

When the camera is connected to the Remote Control TR-1, the camera status lamp lights white.

Note

After running the plug-in “REMOTE CONTROL”, the response speed of the wireless LAN slows down until the connection between the camera and the Remote Control TR-1 is established.

Disconnecting the Remote Control TR-1 from the Camera

1. Press and hold the mode button.

The camera status lamp turns off, and the Remote Control TR-1 is disconnected from the camera.

Resetting the Connection Information

When you want to connect another device to the camera or when the Remote Control TR-1 cannot be connected correctly, press and hold the wireless button to reset the connection information.

Caution

If you reset the connection information, the wireless LAN password is also reset.

Supplementary Information